Download GeoExplorer 2005 Series Getting Started Guide

Using GPS
redirected to the real-time GPS COM port (COM4). Trimble
applications, such as GPS Controller, handle the redirection
automatically. If you are using any other application to set up and
monitor real-time sources, use GPS Connector to redirect the input
to COM4 (see below).
GPS Connector
The GPS Connector software is
pre-installed on all GeoExplorer 2005
series handhelds.
To open GPS Connector, tap
/ Settings / Connections / GPS
Connector.
The GPS Connector software lets you
connect the GPS COM ports to COM1
or Bluetooth ports and configure port
settings such as the baud rate. GPS
Connector software has a graphical
display that shows all active
connections, and a text display that
shows connection messages.
Use the GPS Connector software to
output NMEA or TSIP messages from
the integrated GPS receiver to another
device, such as an external data
collector.
Note – If you are using a Bluetooth port,
enable and configure the Bluetooth Serial
Port service before you connect to the
port.
GeoExplorer 2005 Series Getting Started Guide 49