Download QRN Quantum Random Number Generator

Transcript
 QRN: Quantum Random Number Generator Structure of the generator As already mentioned above, the photon detector exploited by the QRN is a SPAD [17] [18]. A SPAD is a diode that is reverse-­‐biased well above its breakdown voltage. Under this operating condition, a single event of quantum nature, namely the absorption of a single photon, causes the generation of an electron-­‐
hole pair, which is accelerated by the high electric field across the junction. The energy of the free carriers is sufficient to trigger a macroscopic avalanche current of few milliamperes through the device. Proper electronics senses and signals the event. The use of a SPAD as a detector has several advantages. Firstly, an event can be triggered both by the “internal” thermal generation process and the “external” photons. A second advantage is that no analogue measurement of voltage or current is needed, since the detector acts as a digital Geiger counter. It follows that no read-­‐out noise is added to the measurement process and no electrical noise affects the ignition of the events, hence the randomness. The QRN is based on an array of 1024 independent SPAD detectors, organized as a 32x32 matrix, fabricated in standard CMOS technology such as the one described in [9]. As shown in Figure 2, each SPAD is controlled by a front-­‐end electronics [10], which provides the correct bias voltage above breakdown, senses the avalanche current and quenches it. After ignition, the SPAD is then reset back to operation after a so-­‐called dead-­‐time. A custom 8-­‐bit Linear-­‐Feedback Shift-­‐Register (LFSR) counts the events and provides them to the off-­‐chip electronics. The LFSR can process a large number of quantum triggering events (e.g. hundreds) before producing the corresponding output bits. A FPGA provides the control signals to the chip. It sets the read-­‐out rate of the bits and reads the counter values. In addition, it implements a basic Pseudo-­‐Random Number Generator (PRNG), KISS (Keep It Simple Stupid) [11], which is used to enhance the security level of the QRN. This generator is initialized once during the start-­‐up phase of the device by using a quantum random stream and it runs indefinitely. When the security option is activated, the XOR between the QRN stream and the PRNG is performed. The output stream remains random even in case of a failure of the QRN. It’s worth noting that the PRNG and the security option were never active during the validation tests of the MPD’s QRN. As shown in Figure 2, the random stream is then processed inside the FPGA by a bit-­‐selector, which removes some of the bits from the stream according with their position in the LFSR counter. The bit-­‐
selector is adjusted depending on the average number of quantum events detected by each cell of the array, in order to obtain an equal probability of obtaining zero and ones. Variable bit-­‐rates from 16 Mbit/s to 200 Mbit/s of random data are obtained after this processing depending on the device grade. Micro Photon Devices S.r.l. – Italy
All Rights Reserved
Page 4