Download ScreenLogic2 Interface User`s Guide

11
Installation
Section 1
Before You Begin
Your ScreenLogic2 wireless Tablet, and in-wall touch screen are pre-configured and ready for operation. The
system hardware includes a Protocol adapter and your choice of wired or wireless interface. The following
describes the different set up options which depend on the type of interface kit being used:
•
iTC15 Kit (P/N 520500) – Includes Protocol Interface Adapter that connects to your existing wireless cable
or DSL Modem. This allows control of IntelliTouch and EasyTouch pool and spa systems via iPhone, iPod,
iPad or PC (requires PC with an Ethernet connection, and Windows XP operating system or later).
•
iTC35 Kit (P/N 520502) – Includes in-wall color touch screen with Ethernet (RJ45) connection and
Protocol Interface Adapter.
•
iTC45 Kit (P/N 520503) – Includes wireless digital Tablet with color touch screen and Protocol Interface
Adapter.
Tools Required
• Wire stripping tool (for stripping cable wires)
• Ethernet connector tool (for custom Ethernet cabling)
Connection Steps Summary
Before connecting the ScreenLogic2 interface, the IntelliTouch or EasyTouch Load Center and Personality Kit
should already be installed. The recommended ScreenLogic2 installation steps are:
Switch power off to the EasyTouch or IntelliTouch Load Center: Before connecting cables to the
ScreenLogic2 Protocol adapter, switch off the power source to the Load Center.
Review the location requirements before installing the Protocol adapter (pages 12 - 14).
Connect the ScreenLogic2 Protocol Adapter (pages 15 - 16): Connect a 22-gauge four-wire cable to
the Protocol adapter and to one of the available COM ports on the circuit board located in the Load
Center. If both ports are in use, you can wire into the COM port connection block.
Start up the ScreenLogic2 System (page 21): Verify cable connections. Power-up the Load Center.
ScreenLogic2 Interface User’s Guide