1
Download User Guide - Freeverb3 Reverb Impulse Response Processor
Transcript
MIDI Operation Lexicon Using Program Change Messages for Program Load The MPX 500 will allow loading of all of its preset and User programs via standard MIDI Program Change messages. It also conforms to the use of MIDI controller 32 to perform Bank Select. The MPX 500 banks are ordered numerically from 0-24. Here’s how it works. If a standard MIDI Program Change is sent to the MPX 500, Program Change messages 0-9 will load programs the first ten programs from the current Bank. If a Bank Select message (controller 32) precedes a Program Change message, any of the MPX 500 programs can be loaded. For example, Program Change 1 with the Plate Bank selected, will cause the Small Plate program to be loaded. Sending controller 32 with a value of 24 (or higher), followed by Program Change 1, loads the first program of the User Bank. Sending controller 32 with a value of 1, then Program Change 2, loads the second program (Slope Down) in the Gate Bank. Sending controller 32 with a value of 8, then program change 4 will load the last program (Slap Chorus2) in the Chorus Bank . Once a bank is selected, all subsequent Program Change messages will select programs within that bank until a new value for controller 32 is received, or until another PROGRAM or BANK selection is made from the front panel. This function can be disabled with the MIDI Program Change parameter in System Mode. MPX 500 Program Banks 0 1 2 3 4 5 6 7 8 48 Plate Gate Hall Chamber Ambience Rooms Tremolo Rotary Chorus 9 10 11 12 13 14 15 16 17 Flange Detune Pitch Delay/Echo Special FX Flange-Delay Pitch-Delay Chorus-Delay Delay-Reverb 18 19 20 21 22 23 24 Flange-Reverb Pitch-Reverb Chorus-Reverb MonoSplitDly MonoSplitRvb Dual Mono User
