Download GraphXMaster C50 User Manual

2- 4
I Section 2: Installation and Setup
0RXQWLQJ#+DUGZDUH
When mounting two bases or two cubes together use a bolt, 3 washers and hex
nut. When mounting a cube to a base or a top cube to a bottom cube, use a bolt
with a spring and flat washer only. Top to bottom mounting doesn’t require the
third washer or hex nut. See Figure 2.3.
)LJXUH#5161#0RXQWLQJ#KDUGZDUH
518
5HPRYLQJ#WKH#
6FUHHQ
It is important that screens (or “dummy screens”) are removed from the cube
before installation begins.
7ZR#SHRSOH#DUH#UHTXLUHG#WR#UHPRYH#WKH#VFUHHQ1
:HDU#JORYHV#SURYLGHG#LQ#WKH#XVHU·V#NLW#ZKHQ#KDQGOLQJ
WKH#VFUHHQ#WR#SUHYHQW#GDPDJH1
7R#UHPRYH#D#VFUHHQ=
1) Have one person hold the screen from the front.
2) Unscrew the four M8 adjustment screws securing the screen to the cube
frame, located at the rear of the cube. See Figure 2.4.
3) Gently, pull the screen off and set aside.
)LJXUH#5171#5HPRYH#VFUHHQ
519
5HPRYLQJ#5HDU#
$FFHVV#3DQHO
After screens are removed from the cube it is necessary to remove the rear access
panel. See Figure 2.5.
1) Loosen the screws (2) located in the top right and left corners.
 2000 GraphXMaster C50 Installation and Maintenance Manual