Download SoC Reference Kit User Manual

SoC Reference Kit User Manual
1.2.7 Baseband and RF Interface Connector
•
Connector: Samtec TOLC-125-02-F-Q-LC.
•
Supported Boards:
– Baseband Adapter Board.
– SiGe SE7351L-AK1.
– SiGe SE7351L-AK2.
– SiGe SE7351L-AK3.
– SiGe SE7351L-AK4.
– SiGe SE7351L-AK5.
– SiGe SE7351L-AK6.
1.2.8 External Processor Interface Connector
•
Connector: 152-pin Mictor Receptacle.
•
External Processor Board: GDA Technologies MPC8560 Mezzanine Card.
1.2.9 Debugger Board Interface Connector
•
Connectors: One (1) Samtec SOLC-130-02-S-LC and One (1) Samtec SOLC-150-02-S-LC.
•
Interfaces to Debugger Board.
1.2.10 RS232 Connector
Connector: Micro D-Sub 9-Pin.
1.2.11 ARM Debug Connector
•
Connector: 2x10 0.1” shrouded male header.
•
Debugger: ARM Multi-Ice.
1.2.12 ARM Embedded Test Module (ETM) Connector
•
Connector: 38-pin MICTOR Receptacle.
•
ETM: ARM Multi-Trace.
•
Supported Mode: Multiplexed, half clock mode.
1.3
SoC Baseband Board Specifications
The SoC Baseband Board and the SoC Reference Board interface via the baseband and RF
interface connector.
•
Connector: Samtec TOLC-125-02-F-Q-LC.
•
Channel BW: 3.5MHz and 7MHz baseband filters selectable by shunt jumper.
•
Rx Inputs: I & Q single-ended inputs on MCX cables.
•
Tx Outputs: I & Q single-ended outputs on MCX cables.
•
Power Supply: ±5VDC powered by the SoC Reference Board, via the power cable.
1.4
SoC Debugger Board Specifications
The SoC Debugger Board and the SoC Reference Board interface via the debugger connector.
•
Connectors: One (1) Samtec TOLC-130-02-S-Q-LC and One (1) Samtec TOLC-150-02-S-Q-LC.
•
ARC Debugger: DB25 female connector attached at the Personal Computer (PC) parallel port.
•
Logic analyzer Interface: Five (5) 38-Pin MICTOR receptacles and ARM external memory
interface, Serial Peripheral Interface (SPI), I2C, Automatic Gain Control (AGC), RF control.
4
September 2005