Download DVR User Manual

Transcript
Button
Preset Button
Cruise Button
Track Button
Wiper Button
Light Button
Clear Button
Fn2 Button
Info Button
Snap Button
Search Button
Cut Button
Backup Button
Zoom Button
PIP Button
Function
To enter into preset setting in PTZ mode
To enter into cruise setting in PTZ mode
To enter into track setting in PTZ mode
To enable wiper function in PTZ mode
To enable light function in PTZ mode
To return to the previous interface
Unavailable temporarily
Get information about DVR like firmware version,
HDD information
To control playback. Play/Pause/Stop/Previous
Section/Next Section/Rewind/Fast Forward
To take snapshots manually
To enter into search mode
To set the start/end time for backup in playback
mode
To enter into backup mode
To zoom in the images
To enter into picture in picture setting mode
◆ Switch Remote Control ID
Take remote control and point to DVR then continuously press “8”,”8”,”ID(0-65535)”,”Enter”.
*The ID must be the same on DVR.
*For example: If ID=1 , please take remote control and point to DVR then press 8,8,1,Enter.
1.4 Control with Mouse
1.4.1 Connect Mouse
It supports USB mouse through the port on the rear panel, please refer to Fig 2.11 Remote Controller.
Notice: If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is connected to the USB mouse port not the USB port
2. try another mouse
1.4.2 System operation by mouse
The structure of the main menu is shown in Fig 2.11 Remote Controller.
In live:
Double-click left button on one camera to be full screen display. Double-click again to return to the previous
screen display.
Click right button to show the control bar at the bottom of the screen as Fig 2.11 Remote Controller. Here are all
control and setup. Click right mouse again to hide the control bar.
In setup:
Click left button to enter. Click right button to cancel setup, or return to the previous.
If want to input the value, move cursor to the blank and click. An input window will appear as Fig2.12. It
supports digitals, letters and symbols input.
Fig 2.12 Digital Numbers and Letters Input Window
Users can change some value by the wheel, such as time. Move cursor onto the value, and roll the wheel
when the value blinks.
7