Download Ethernet Routing Switch 8300

10. Documentation Corrections
The following items in the Nortel Ethernet Routing Switch 8300 Administration (NN46200604) Release: 4.2 Document Revision: 02.02 contain the following inaccuracies:
Table 2 on page 31:
CLI flag
NNCLI flag
-----------------------------------------------------------jumboframe <true|false> jumboframe <yes|no>
Switch reset required
no => should be yes
User will see the following upon trying to enable jumbo frame support:
8300:5# config boot flag jumboframe true
WARNING: The change made will take effect only after
the configuration is saved and the chassis
is rebooted.
WARNING: All those modules that do not support jumbo
frames will be taken off-line if jumboframe is enabled.
Table on page 85-86 (Q02102588)
The following "config sys set xxx" variable definitions listed do not exist on the ERS8300;
These parameters only apply to an ERS8600.
ecn-compatibility <enable|disable>
global-filter <enable|disable>
mgmt-virtual-ip <ipaddr/mask>
mtu <bytes>
vlan-bysrcmac <enable|disable>
You cannot enable BPDU Filtering and configure filters on the same port. If you attempt this
configuration, the switch generates an invalid operation warning message. This restriction is missing in
the user manual (Configuring Security: NN46200-205).
11. Mib Objects
The following mib objects are newly added:
rcChasForceTopologyIpFlagEnable
rcChasCircuitlessIpId
[Q01986219]
rcSyslogGlobalHeader
[Q02094946]