Download "user manual"

Transcript
Always select this item if you wish to quit the menu without taking any action.
The previously triggered alarms are reset with the
key in the menu items Pre-alarm off and Main alarm off. The
configuration selected in the main menu is then reset.
The limit of the pre-alarm can be set as a percentage of the main alarm limit in the menu item Alarm limits. Set levels in
5% steps between 5% - 95% with the or key. The new pre-alarm limit is saved with the ENTER key and you will be
returned to the main menu.
The following sections explain those actions which can be carried out when a menu item is selected.
6.3.5 Reset a pre-alarm
If a pre-alarm is triggered for a configuration in the measuring mode the yellow LED on the front of the DTECT X1 s
device comes on.
To reset the pre-alarm,
first find the configuration which has triggered the pre-alarm. Select the configuration
"Select a configuration" 38 ), this being marked by a "V" in the first line of the display.
38
with the
or
key (see
Press the ENTER key to enter the sub-menu.
Select the Pre-alarm off menu item with the
or
and
confirm this menu item with the ENTER key.
Display to reset a pre-alarm limit
The pre-alarm will be deleted and you will be returned to the selected configuration in the main menu.
6.3.6 Reset a main alarm
If a main alarm is triggered for a configuration in the measuring mode the red LED on the front of the X1 s device. The
corresponding configuration will be skipped in subsequent measurements at the default configuration.
The main alarm has to be reset before the configuration can be restored to the measuring cycle. Proceed as follows:
Find the configuration 38 which has triggered the main alarm with the
or
The configuration is marked by the letter "H" in the first line of the display
key (see "Select a configuration"
38 ).
Press the ENTER key to enter the sub-menu and
select the Main alarm off menu item with
or
key.
Confirm this menu item with the ENTER key.
Display to reset the main alarm limit
The main alarm will then be deleted and you will be returned to the selected configuration in the main menu.
6.3.7 Set a pre-alarm limit
You can only set the limits for the pre-alarm of the first frequency band or characteristic value via the control panel of the
DTECT X1 s device. 5% step values between 5% and 95% of the main alarm limit are possible.
You can only define the main alarm limit itself with the Configuration Manager of the Administrator software on the
external control computer.
40