Download Zycont User`s Guide - Duplicator Technical Support

Tutorial Guide
Making Disc-to-Disc Copies
This process will copy a Master disc onto several blank discs simultaneously.
Due to it’s simultaneous nature, a good condition Master disc and lower recording
speed is necessary for both higher duplication success rates and good
quality duplicates.
Turn on your duplication system. Once the controller has completed its self
tests, you should see the following screen:
Copy
<mode
Step 1: Make sure the Master reading source is set to Reader. If your duplication
system does not have a hard drive inside, skip to Step 2 on page 17.
Note: It is very important to make sure that your current Master
Reading Source is the top tray in order to avoid unnecessary error
Messages
.
a. To check the Master reading source, press and hold the <MODE> button
for three seconds and release it after a beep has sounded. You should then see
following screen:
Setup
<mode
Go>
b. Press the <GO> button repeatedly until the following screen is shown:
CD to CD
[*] XXX
[Q]
Where XXX is either Yes or No.
c. Press the <MODE> or <BACK> buttons repeatedly to set this option to
Yes as shown in the following screen, and press the <GO> button to confirm.
CD to CD
[*] Yes
[Q]
MODECK
15