Download Building Secure SANs TechBook

Transcript
Brocade Encryption Switch/Blade
◆
"Step 3: Plan the encryption management" on page 166
◆
"Step 4: Place EEs in the fabric" on page 167
◆
"Step 5: Plan key vault configuration and administration" on
page 167
◆
"Step 6: Consider multipath access and failover" on page 167
◆
"Step 7: Create CTCs" on page 168
Note: The reference architecture uses the PB-DCX-16EB encryption blades for
the ED-DCX-B as opposed to the standalone Brocade Encryption Switch.
Step 1: Configure the Brocade fabric
In order to configure the Brocade fabric, identify the following:
◆
The data, (files, applications, and so on) that need to be encrypted
◆
The number of initiators requiring encryption services
◆
The target ports correlated to the identified initiators
◆
The LUNs correlated to the initiators and targets
◆
The number of paths used for accessing the LUNs for initiators
and targets
Note: CTCs can be comprised of a mixture of both encrypted and cleartext
LUNs. Cleartext I/O flows move through the encryption engines and will
therefore cut into the total available EE bandwidth. For example, if you had
48 Gb/s of traffic flows for cleartext LUNs added via CTCs, you would only
have 48 Gb/s left for encrypted flows.
Step 2: Plan the encryption solution
Perform the following audits:
◆
Security audit of personnel such as administrators, managers,
contractors, and so on
◆
SAN audit including physical location of equipment and existing
zoning configuration
◆
Bandwidth requirement audit
Step 3: Plan the encryption management
Evaluate the following:
166
◆
The Command Line Interface (CLI) use
◆
Security Officers
Building Secure SANs TechBook