Download EN-MOTION - ProTerapi A/S

Inclination buttons [10]
Figure 15
The incline can be selected or changed at any time using the inclination buttons [10]. Pressing the + button
increases the angle by +0.5%. The – button decreases the angle of inclination. Starting from 0 (zero), a
negative angle of inclination (downhill) can be selected by pressing the – button. Pressing and holding down
an inclination button will change the incline continuously, i.e. more quickly.
8.2.9 Height-adjustable side support buttons (only EN-Motion ‘Plus’ model)
Using the two buttons [1] on the sensor unit, you can easily adjust the height of the side supports. Pressing the
left-hand button (up arrow) will automatically raise the side supports (electrically). The right-hand button will
lower the side supports. The side supports can be adjusted over a distance of 30 cm.
Figure 16
8.2.10 Safety belt with magnetic contact
This safety feature consists of a belt with an attached cord [3]. A magnet has been placed at the end of the
cord. In the event of danger (for example, if the patient stumbles or is in danger of falling), the contact between
the magnet and the control panel will be broken. The treadmill will then stop automatically. The safety belt must
be worn by the runner when using the treadmill. A message on the screen will draw the attention of the user or
therapist to the fact that the band has been stopped by means of an emergency stop.
Please note: the magnetic contact has been designed to interrupt the power supply of your treadmill
when it is activated. The treadmill will not restart until the magnet has been placed in position once again.
8.2.11 Emergency stop button (optional)
The emergency stop [2] is an optional accessory which is used to quickly bring the band to a standstill. In
principle, the emergency stop can be attached to the handles at any desired location (see the installation and
instruction manual for the emergency stop). Pressing the red button will activate the emergency stop. At the
same time, a message will appear on the information screen (see figure 18). The band can only be restarted by
first returning to the Main menu and reselecting the desired training. The emergency stop is connected to the
sensor unit (via the input at the bottom of the sensor unit).
Figure 17
Figure 18
19