Download Manual - Videcon

2. INTRODUCTION
GENERAL
The RX10X telemetry interface is designed to allow control of a variety of integrated dome cameras
using BBV’s range of up-the-coax telemetry transmitters. See appendix A for a complete list of
supported domes.
RX10X TECHNICAL SPECIFICATION
Power Requirements:
12 – 36VDC
24VAC from the dome supply (excluding the Dennard dome)
This unit is supplied with a 2.1mm Jack power fly lead. In addition a
PSU 3 (12V 1A in line PSU) can be ordered from BBV
Current Consumption:
100mA maximum @ 12VDC
Features:
• Two PCB construction.
• Serial data output 2 wire RS232/422/485
• Up to 16 preset positions can be stored within the RX10X
Engineering Facilities:
•
•
•
•
Unit auto-tunes to the coaxial telemetry signal
7 Segment LED readout for continual system status
Data out LED
Video launch amplifier provided with Gain and Lift controls
.
Telemetry Signals:
Telemetry signals either:
• Up-the-coax max distances: 250M of RG59
500M of CT125/RG11
• Or twisted pair 0-20mA current loop: 300 Ohm close loop impedance
maximum
Video Input:
Video Output:
1V p-p 75Ω terminated input via BNC socket
1V p-p to V p-p 75Ω impedance via BNC socket
Presets:
Up to 16 full scene preset positions can be stored within the interface
depending upon the model of dome
Dimensions:
Length
Width
Height
69mm
57mm
36mm
Weight
130 grams
Temperature range:
-10° Celsius to +40° Celsius
RX10X installation manual V1.05 14 Aug 10
Page 5