Download CNC 8055 TCO/MCO

CNC 8055-CO
3.3
SEARCH FOR MACHINE REFERENCE ZERO (HOME)
The search for machine reference zero can be done in 2 ways:
Search for machine reference for all the axes
The CNC will execute the machine reference zero routine defined by the
manufacture in the general machine parameter P34 (REFPSUB).
Warning:
The CNC saves the part zero or zero offset that is active at the time.
If no home searching subroutine is defined, the CNC will display the
relevant error message.
Search for machine reference zero for only one axis
Carries out the home search on the X axis
Carries out the home search on the Z axis
Warning:
The CNC does not save the part zero or zero offset that is active at the
time and assumes as new part zero the position taken by machine
reference zero (home).
Chapter 3 - page 7