Download User Manual

5.0 Installation & Setup
5.5 Installing Optional Extension Tables (Front Guard Machines Only)
Using the wood screws provided, attach a back plate to each extension table. Using (4) 3/8-16
capscrews, attach the table support to the under side of the main table as shown in (Figure 11).
Route each cut button wire through the slots in the bracket and relocate the cut buttons to the
extension tables (as shown). Place the provided flat washers on the table support above each slot
receiving a screw to mount the extension table on the support. Lay the table extension on top of the
spacers and insert the screws. Slide the table extension tight to the table. Shim the extension tables
as necessary to make the tables flush using the provided shims.
Figure 11
5.6 Hydraulic System Check
The cutting/clamping mechanism of the Titan 200 is powered by a hydraulic system consisting of an
electric motor coupled directly to a hydraulic pump.
The hydraulic reservoir holds 4 quarts (1 gallon) of hydraulic fluid. It is filled with Rykon 100 hydraulic
fluid at the factory but should be checked before operation. Remove the lower rear panel cover and
unscrew the cap on top of the tank (Figure 12 on page 15). Fluid level should be at 1/8” from the end
of the dip stick (check with dip stick cap screwed in). Add fluid if necessary but avoid overfilling as
this could cause leakage when hot. Replace the rear panel when finished. For more information
about checking and changing the hydraulic fluid, including a cross-reference chart of approved fluids,
see the Titan200 Technical Service and Parts manual.
The hydraulic fluid should be checked weekly and changed AT LEAST ONCE-A-YEAR or after every
1,000 hours of operation.
14