Download Operator`s Manual

Unpacking
Upper, Middle and Lower Frame
Assembly
Carton Contents:
1. Secure the connection of the middle handle assembly to
the upper handle by fastening the handle locks on each
side (Fig. 1).
• Electric snow thrower with handle
• Chute crank rod with cotter pin
• Handle knobs/Deflector knobs (4)
Fig. 1
• Square J-bolts (2)
• Carriage bolts (2)
• Rubber washers (2)
• Chute deflector
• Manual with registration card
1. Carefully remove the electric snow thrower and check to
see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe® + Sun Joe® customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the electric snow
thrower. The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations or save the packaging for long-term
product storage.
2. Align the holes in the bottom of the middle handle
assembly with those in the lower handle (Fig. 2).
3. Secure the middle handle assembly to the lower handle
using 2 handle knobs and 2 square J-bolts. Install the
knobs on the inside of the unit, and tighten (Fig. 2).
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils, or small
parts. These items can be swallowed and pose a suffocation
risk!
Fig. 2
Assembly
m
CAUTION
m
Square
J-bolts
Inspect wiring, which, if damaged during shipping,
may cause serious bodily injury during equipment use.
If any damage is seen or suspected, do not assemble.
Instead, contact the Snow Joe® + Sun Joe® customer
service center at 1-866-SNOWJOE (1-866-766-9563)
for assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
6
Handle knobs