Download User Manual

Configuration and Parameters
iPar Settings
These parameters are accessible in the [CONFIGURATION] (COnF), [FULL] (FULL),
[COMMUNICATION] (COM-) menu and [COMMUNICATION CARD] (Cbd-) submenu.
The following table describes the parameters related to the iPar settings server function
Parameter Description
(HMI mnemonic)
Range or Listed Values
Default
Long
Name
Short
Name
Access
Parameter
Number
[iPar Validation] (IPAU)
Enable iPar service
0: no
1: yes
0
[No]
[Yes]
(nO)
(YES)
R/W
64274
[iPar Autosave] (IPAS)
Enable iPar autosave service
0: no
1: yes
0
[No]
[Yes]
(nO)
(YES)
R/W
64275
[iPar timer] (IPAt)
Interval for periodic saving of the
iPar service
0: no autosave
1 to 9999 (minutes)
10
–
–
R/W
64278
[iPar Error Mgt] (IPAF)
Enable iPar detected error
management
0: no
1: yes
1
[No]
[Yes]
(nO)
(YES)
R/W
64277
[iPar Local Conf] (ICFG)
Selection of local or server
configuration
0: The drive configuration is downloaded
0
from the iPar server at Power-onof the drive.
1: The drive configuration is local.
[No]
[Yes]
(nO)
(YES)
R/W
64276
[iPar Status] (IPAE)
iPar service status
0: idle state
1: initialization
2: configuration
3: ready
4: operational
5: not configured
6: Unrecoverable detected fault state
[IDLE]
[INIT]
[CONF]
[RDY]
[OPE]
[UCFG]
[UNREC]
(IdLE)
(INIt)
(CONF)
(rdY)
(OPE)
(UCFG)
(UrEC)
R
64279
[iPar Error Cod] (IPAd)
Detected error code
0: No detected error
0
1: Stored configuration is not ok
2: No configuration file on the IPAR server or
configuration is not compatible. (Served
configuration is not ok)
3: Detected error connection to the IPAR
configuration file on the server.
4: Detected error writing the configuration file
to the server.
[0]
[1]
[2]
(0)
(1)
(2)
R
64280
[3]
(3)
[4]
(4)
22
HRB25668 10/2013