Download Modbus ASCII Slave
Transcript
Diagnostics of the Communications FB 11.1.1 Errors during “Initialization” “Error during Initialization” ERROR_No (decimal) ERROR_INFO Error Text Remedy 0 0 no error 1 SFC51 Æ RET_VAL Error when reading SZL with SFC51. 2 FB8 Æ STATUS Timeout when initializing CP or Check if protocol “Modbus Slave” error when initializing CP (Error has had parameters assigned on in SEND job). this interface. Analyze Analyze RET_VAL in ERROR_INFO, eliminate cause. ERROR_INFO. 11.1.2 Errors during “Processing of Function Codes” “Error during Processing of Function Codes” ERROR_No( ERROR_INFO decimal) Error Text Remedy 10 Processing Code Illegal processing function transferred by the driver to the communications FB. Restart CP (Mains_ON) 11 Start Address Illegal start address transferred by the driver to communications FB. Check Modbus address of Modbus master system. 12 Amount of Registers Illegal amount of registers transferred by the driver to communications FB: Amount of registers = 0. Check amount of registers of Modbus master system, if required restart CP (Mains_ON) 13 Amount of Registers Illegal amount of registers transferred by the driver to communications FB. Check amount of registers of Modbus master system, if required restart CP (Mains_ON) 14 Memory bits M End Address Attempted access to SIMATIC memory area “memory bits” in excess of range end. Attention: Range length in SIMATIC CPU is CPU type-dependent. Reduce Modbus start address and/or access length in Modbus master system. Loadable Driver CP341: MODBUS ASCII Slave with 32-Bit Extension 6ES7870-1CA00-0YA0; Manual Edition 1.0 11-2