Download "user manual"

Transcript
page 45 of 53
➨Slip connection hose onto hose connector
below the housing cover.
➨Close hose clip with flat pliers.
Assembling the fittings
➨Attach the handle at the housing cover (use
5 mm wide Allen key)
➨Slip the hose onto the hose connector by
turning the fitting (L) with an open-ended
wrench w/f 14.
➨Tighten the union nut (K) of the hose connection with an open-ended wrench w/f 17.
+Tighten the union nut first by hand and then
tighten one full turn using the open ended
wrench.
Checking the ultimate vacuum
➨ After any intervention at the equipment (e.g., repair / maintenance)
the ultimate vacuum of the pump has to be checked. Only if the pump
achieves its specified ultimate vacuum, the pump’s leak rate is low
enough to ensure that no explosive atmospheres will occur in the interior of the equipment.