Download Moisture Analyzer User Manual

5.4.
If you plan to use a printer, electronic balance, and/or computer connect them to the
marked connectors at the back of the instrument. The accessory keyboard connects to a
fitting on the side nearest the printer connector of the instrument.
5.5.
Power control and fuses are located at the rear of unit.
5.6.
The power entry module must be configured for the
voltage supplied to it. This will be either 100 to 120
VAC or 220 to 240 VAC (window shows either 110V120V or 220V –240V). Countries using 100 VAC will
use the 110-120V setting. The unit is configured at the
factory for the destination country at time of shipment.
However, to ensure the unit is configured correctly for
your application, verify the rating is correct on the power entry module on the rear of the
instrument.
Page 11