Download Tri Auto mini - Technomedics

Install File Electrode
4
5
File release button
File Electrode
Swing the electrode back as shown in the illustration.
Hold down the file release button.
Insert the file and turn it back and forth until it lines up
with the latch mechanism.
Push the file all the way into the latch. Release the
file release button.
6
Push the file electrode down so that it pinches the file as
shown in the illustration.
Inserting and removing files without holding the file release button down will damage the chuck.
Do not let the electrode pinch the cutting part of the file.
The file electrode may not fit on some types of files.
The file electrode cannot be used for files with a shank diameter greater than 1.2 mm, files with large cutting heads such as largo burrs, files with shanks that
are not round and Gates Glidden drills.Do not mix up the black screw used for the cap and the silver screw used for the electrode.
•• Use caution when inserting and removing files to avoid injury to fingers.
•• Make sure the file goes all the way in. Give the file a light tug to make sure it is properly installed.
17
Operation 2010-12-16