Download Working Notes Section One - Better Photos

Transcript
Blur
It's important to remember that the term "blur" means there was movement the shutter
speed did not stop. People often use the term "blur" when what they really mean is "out of
focus." TIP - the background of a picture is only blurry if there's motion involved. And there
are only two possible causes of blur - subject movement (like someone walking, as discussed
above) or camera movement. Both subject movement and camera movement can be affected
by shutter speed. Fast shutter speeds can stop most if not all motion, and can minimize blur
caused by camera movement. As stated, camera movement can also cause blur, most of the
time from not holding the camera steady enough. If you're moving the camera when taking a
picture, that movement can show up as blur in your photo (which is what happens when you
use panning). Good technique - elbows against the body, left hand under the lens (cradling it),
and pressing the viewfinder against your eye - will help you hold the camera more steadily.
Then gently press the shutter button, instead of "punching" it. With good technique, you
should be able to shoot hand-held, at 1/100 second or even slower, and get a sharp picture of
a non-moving subject.
However, the longer the lens you use (such as a 200mm or 300mm telephotos), the more
likely you’ll see blur caused by camera shake. TIP - longer lenses magnify the image, which is
what we want, but at the same time they magnify any movement of the lens and camera. A
good rule of thumb is to avoid shutter speeds slower than 1/focal length of the lens when
hand holding the camera. In other words, with a 300mm lens, 1/300 is the slowest you should
shoot. Shorter lenses tend to show shake less, so the formula for a 35mm lens would be 1/35
second.
The introduction of Vibration Reduction lenses (VR, also known as image stabilization
technology) has changed this formula somewhat. These lenses shift elements to counter
camera shake, so it’s often possible to shoot two-to-four stops slower than before. That would
mean you may be able to shoot a 200mm Vibration Reduction lens at 1/50 of a second,
instead of the more traditional 1/200 second. Of course, the steadier you are, the better your
chances of getting a shot without blur. And VR does nothing to stop your subject’s movement
– it only reduces blur coming from operation of the camera. Finally, check the user manual for
your lens to see if VR should be left on when the camera is used on a tripod. Since you don’t
need VR when solidly locked down on a good tripod, it’s sometimes easiest just to turn it off
anytime on a tripod.
TIP - some VR lenses offer both “Normal” and “Active” VR. Normal is the right one to use most
of the time. Active is for when what you’re on is moving - a boat, train or plane.
There are other ways to reduce the chance of camera movement as well. Tripods, monopods,
leaning against a wall or lying on the ground are all good ways to steady the camera.
It's important to remember that as much as we often work to avoid blur, creative use of
shutter speed goes further than simply stopping action. By using slower speeds, and allowing
4