Download EWDMX IP User Manual ver 1

w w w . e l a t i o n l i g h t i n g . c o m DEVICE INSTALLATION
FLAMMABLE MATERIAL WARNING
Keep fixture at least 5.0 ft (1.5m) away from any
flammable materials, decorations, pyrotechnics, etc.
ELECTRICAL
CONNECTIONS
A qualified electrician should be used for all
electrical connections and/or installations.
CAUTIONS
For added protection, mount the device in areas outside walking paths, seating
areas, or in areas were unauthorized personnel might reach the fixture.
Before mounting the device to any surface, make sure the installation area can
hold a minimum point load of 10 times the weight of the fixture.
Device installation must always be secured with a secondary safety attachment,
such as an appropriate safety cable.
Never stand directly below the device when mounting, removing or servicing.
The applicable operating temperature for the device is between -10°C to 45°C.
Do not use the device under or above this temperature range.
Ensure ALL connections and end caps are properly sealed with a dielectric
grease (available at most electrical suppliers) to prevent water corrosion and/or
electrical short circuit.
INSTALLATION VIA INCLUDED BRACKET
TRUSS MOUNTING INSTALLATION
1) Insert the quick-lock fasteners of the
included bracket into the respective holes on
the bottom of the device. Tighten the
quick-lock fasteners fully clockwise.
2) Loop the safety cable through the opening
on the bottom of the base indicated by red
arrow, and over trussing system or a safe
fixation spot. Hook end of the safety cable on
to the attached carabineer.
PERMANENT INSTALLATION
1) Remove attached mounting bracket and
set on a flat surface or secure to a wall using
the 2 slotted screw-mounting points.
11
EWDMX IP™ User Manual ver 1