Download vertical multi-stage

SECTION: B - Identification, service and technical
support
B-1) Preface:
The name plate indicates the type series / size, main
operating data and identification number. Please quote this
information (first two lines*) in all queries, repeat orders
and particularly when ordering spare parts. If you need any
additional information or instructions exceeding the scope
of this manual or in case of damage please contact BPPumps’s nearest customer service center.
The following address data are available for service and
technical support:
Crane Pumps & Systems
service department
420 Third Street
Piqua, Ohio 45356
Tel: +1 937 7732442
Fax: +1 800 3287573
Internet: www.cranepumps.com
B-2) Nominal current:
The maximum allowable current of the motor is mentioned
as I.max. on the motor plate. This maximum allowable
current shows the maximum working range of the motor
and can be used to protect the motor.
IMPORTANT
Be careful in using it this way, because, not
only the motor, but also the pump has to be
protected in its application.
Indication
BPV
Seq. Nr
Ca / Sic / EPDM
PN
Q
H
n
Meaning
Pump type *
Sequence number *
Rotating part mechanical seal (Carbon) *
Stationary part mechanical seal (Siliconcarbide) *
Static sealing, O-Rings (EPDM) *
Pressure class (flange) connection *
Nominal capacity (see Q/H curve above)
Nominal head (see Q/H curve above)
Nominal rotation speed
4-40
Ca
Sic
EPDM
10
GPM
PSI
1/min
On the pump plate (sleeve sticker) this “pump current at
400 Volts” will be mentioned as I nom, and can be used
to pre-set the motor protection switch to protect the pump/
motor combination.
This current value can also be used to determine the
proper electrical equipment such as variable frequency
drive, main switch, wiring diameter etc.
B-3) Supplementary documentation:
Apart from the manual, the documentation given below is
also available.
4