Download Operating Manual

52
mono-mix fu
Description of the Machine
2.2 Switch Cabinet
6.6 Removal of Blockages
The electrical fittings comply with VDE regulations.
WARNING
Hoses could explode or material be projected if
blockages occur.
The machine must be switched off immediately at
the double push button “On/Off”.
4 5
6
• Set reverse switch “Motor forwards/reverse” to
position 2 = reverse
• Switch the machine on at the double push button
“On/Off” and allow it to run until the pressure in
the mortar hoses is zero.
3
7
8
2
9
1
WARNING
Hose couplings or material could be projected
forcefully when opening hose couplings.
Make sure that mortar and hoses are fully
depressurized before uncoupling them.
Before opening the couplings:
- wear regulation goggles,
- check pressure on hose-pressure gauge and cover
couplings with a tarpaulin.
Do not face the coupling directly when opening it.
13 12 2 11
10
Fig. 3: Switch cabinet
1
2
3
4
5
6
7
8
9
10
11
12
13
387604 – 04/03
• Switch machine off at double push button “On/Off”
• Clean the mortar hoses (see “Cleaning mortar
hoses”, page 56)
• Re-connect the mortar hoses securely
• Set reversing switch “Motor forward/reverse” to
position “1 = forward”
• Switch machine on at double push button “On/Off”
387604 – 04/03
!
21
Safety socket 250 V for connection of compressor or optional
water pump
4-pole socket for control cable of pressure monitor “Air” or
fine-plaster spraying unit
4-pole cube plug for connection of a vibrator
Main switch
Double push button “On-Off”
Push button “Water infeed”
Pole-changing switch “motor forward/reverse”
Signal lamp “Fault frequency inverter”
4-stage switch “motor speed”
Connection for pressure monitor “water”
Connection for solenoid valve
Power cable “motor”
Input socket 250 V, L6-20A 3-pole