Download Installation Instructions

24.
Reconnect the front track bar to the axle mount with the original hardware.
Torque bolt to 50 ft-lbs.
Step 24 Note
25.
Torque the lower control arm bolts to 85 ft-lbs.
26.
Check all hardware for proper torque.
To aid in aligning the track bar
hole have an assistant turn the
steering wheel to shift the trackbar
in the correct direction.
»»R
ear Installation
1.
(TJ and ZJ Models)
Disconnect the rear track bar from the passenger’s side frame mount Figure 6.
Save hardware.
Step 25 Note
If working on a ZJ or 97 model TJ,
be sure to align the marks made at
the beginning of the installation
before tightening the bolts.
Figure 6
2.
Raise the rear of vehicle with a hydraulic jack and place jack stands under the
frame rails, just ahead of the lower control arm pockets.
3.
Remove the wheels.
4.
Support the rear axle with a hydraulic jack. Disconnect the shocks from the
axle. If replacing the shocks, disconnect them from the frame mount also and
remove them from the vehicle. Save all shock hardware.
5.
Disconnect the sway bar links from the sway bar Figure 7. Save hardware.
Step 5 Note
TJ sway bar links are shown in the
figure. ZJs use a stem style link.
Remove the nut, washer and bushing to disconnect the sway bar.
Save all hardware.
Figure 7
J2200 Installation - pg. 5