Download P4105 Installation Instructions

CHECK CLEARANCE AND TIGHTEN ALL FASTENERS
Check clearance and operation of foot brake
and shift lever. Check clearance of Highway Bar
at a full fork lock left and right. Adjust as
necessary.
12. Tighten all Screws (left and right side) at the lower
mount points to the specified torque in your service manual.
Tighten the 4 Whizlock Nuts firmly. (8mm Hex and 1/2”
Socket) Figure 11.
13. Reinstall the Wire Connector Cover. (Hex Key)
Figure 12.
Check hardware for tightness after you ride the motorcycle. Re-tighten fasteners if necessary.
MAINTENANCE / CAUTION
The high quality chrome finish of your National Cycle
Highway Bar can be maintained with any quality chrome
cleaner or polish applied with a soft cloth.
Check hardware for tightness regularly. Never
ride with loose mounting hardware. Check to
be sure your Highway Bar does not contact
any part of the motorcycle at a full turn left and right.
Correct any problem before using the motorcycle.
Figure 11
If the additional of an accessory(ies) adversely affects
your motorcycle’s stability immediately remove the
accessory(ies). Do Not ride a motorcycle that exhibits
unsafe handling traits. Have experienced service
personnel correct any problem before riding with the
accessory(ies) installed. For further questions concerning handling problems associated with an
accessory(ies), contact your dealer, motorcycle manufacturer, or accessory manufacturer.
Figure 12
©2005 National Cycle, Inc. PO Box 158, Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e mail: [email protected]
Page 4 of 4
10-114858-000 09/06