Download D2064-1TR8 - Cessna Support

Transcript
CESSNA AIRCRAFT COMPANY
MODEL 152 SERIES
SERVICE MANUAL
INSPECTION TIME LIMITS
1.
Inspection Items
REVISION
STATUS
TASK
INTERVAL
OPERATION
ZONE
Inspect aircraft records to verify that all applicable
Cessna Service information Letters, Cessna Service
Bulletins and Supplier Service Bulletins are complied
with.
Every 100 hours or
12 months
1
-
Inspect aircraft records to verify that all applicable
Airworthiness Directives and Federal Aviation
regulations are complied with.
Every 100 hours or
12 months
1
-
Inspect aircraft records to verify that all logbook entries
required by the Federal Aviation Regulations are
complied with.
Every 100 hours or
12 months
1
-
Inspect aircraft records to verify that all SID Inspections
have been complied with as scheduled.
Every 100 hours or
12 months
1
-
Inspect rudder pedal torque tube, shafts, support
brackets and cable attachment arms.
Refer to
2A-14-01,
Supplemental Inspection Document
27-20-01, for inspection procedure.
Initial: 10,000 hours 7
or 20 years; repeat:
3,000 hours or 5
years
211
Elevator trim system. 1. Inspect elevator trim brackets
and actuator support brackets. 2. Inspect pulleys,
attaching structure and fasteners. Refer to Section 2A14-02, Supplemental Inspection Document 27-30-01,
for inspection procedures.
Initial: 1,000 hours; 14
repeat: 1,000 hours
330,
340
This inspection is for mild/moderate corrosion
Inspect main landing gear tubular
environment.
spring for rust or damage to finish. Inspect entry step
attachment. Refer to Section 2A-14-03, Supplemental
Inspection Document 32-13-01, for inspection
procedure.
Initial:
20 years; 11
repeat: 10 years
730,
740
This interval is for severe corrosion environment.
Inspect main landing gear tubular spring for rust or
damage to finish. Inspect entry step attachment.
Refer to Section 2A-14-03, Supplemental Inspection
Document 32-13-01, for inspection procedure.
10 years; 13
Initial:
repeat: 5 years
730,
740
Inspect main landing gear fittings and attachment
of the fittings to the bulkheads. Refer to Section
2A-14-04, Supplemental Inspection Document
32-13-02, for inspection procedure.
Initial: 3,000 hours
or 5 years; repeat:
1,000 hours or 5
years
15
210
Inspect nose landing gear torque links, bolts, bushings
and fork. Refer to Section 2A-14-05, Supplemental
Inspection Document 32-20-01, for inspection
procedure.
Initial: 3,000 hours 8
or 5 years; repeat:
3,000 hours or 5
years
D2064-1-13 Temporary Revision Number 8 - May 18/2015
© Cessna Aircraft Company
720
2A-10-01
Page 1
Oct 2/1995