Download Operator`s Manual

Transcript
 NOTE: Changing one pad at a time  NOTE: When new brake pads are
will prevent one piston from pushing
out the other piston from the caliper.
6. Measure the thickness of the brake
pad. The brake pad thickness must
be greater than 5.0 mm (0.20 in.). If
the brake pad thickness is less than
specified, replacement of both pads
is necessary.
installed, a “burnishing” process is
required (see Burnishing Brake Pads
sub-section).
Burnishing Brake Pads
After changing brake pads, the new brake
pads must be burnished to achieve full
braking effectiveness. Braking distance
will be extended until brake pads are
properly burnished.
To properly burnish the brakes, use following procedure:
1. Choose an area sufficiently large to
safely accelerate to 30-40 mph and
to brake to a stop.
 NOTE: This procedure can also be
PC011A
7. Using a flat-blade tool, slowly and carefully push the piston into the caliper.
accomplished using a shielded jack
stand.
2. Accelerate to 30-40 mph; then compress brake lever to decelerate to a
stop.
8. Position the outer brake pad into the
caliper; then install the hair-pin clip  NOTE: Lightly apply the brake
lever to come to an easy stop; do not
into the caliper assembly.
over-apply brakes or “lock up” the
9. Repeat steps 5-8 for the inner pad; then track.
secure the pad with the hairpin clip.
3. Repeat procedure 10-15 times
10. Remove the reservoir cover and
allowing some cooling between
remove the remaining fluid; then fill
stops.
the reservoir with fresh fluid and
 NOTE: Do not repeat too soon or
install the cover.
too aggressively as to get the brake
11. Pump the brake lever to ensure cor- disc “red hot.”
rect positioning of the brake pads
and proper brake lever travel (see
! WARNING
Checking Brake Lever Travel subDo not attempt sudden stops or put
section); then release.
yourself into a situation where a sud-
 NOTE: If brake lever travel is not den stop will be required until the
within specification, bleed the brake brake pads are properly burnished.
system (see Bleeding Brake System
 NOTE: This procedure stabilizes
sub-section).
the pad material and extends the life
12. Remove the reservoir cover and fill of the pads.
the reservoir (if necessary) to the
proper level with fresh brake fluid; Drive Belt
The drive belt transfers power from the
then install the cover.
drive clutch to the driven pulley. If the
13. Secure the brake shield, the driven belt is worn, cracked, or stretched, maxipulley (tightened to 20 ft-lb), and the mum power will not be transmitted and
rear belt guard; then close and the belt could also fail and therefore must
secure the left-side access panel.
be replaced. Periodic checks (at least
once a month under normal usage) of two
drive belt specifications are essential.
43