Download Operator`s Manual
Transcript
NOTE: Changing one pad at a time NOTE: When new brake pads are will prevent one piston from pushing out the other piston from the caliper. 6. Measure the thickness of the brake pad. The brake pad thickness must be greater than 5.0 mm (0.20 in.). If the brake pad thickness is less than specified, replacement of both pads is necessary. installed, a “burnishing” process is required (see Burnishing Brake Pads sub-section). Burnishing Brake Pads After changing brake pads, the new brake pads must be burnished to achieve full braking effectiveness. Braking distance will be extended until brake pads are properly burnished. To properly burnish the brakes, use following procedure: 1. Choose an area sufficiently large to safely accelerate to 30-40 mph and to brake to a stop. NOTE: This procedure can also be PC011A 7. Using a flat-blade tool, slowly and carefully push the piston into the caliper. accomplished using a shielded jack stand. 2. Accelerate to 30-40 mph; then compress brake lever to decelerate to a stop. 8. Position the outer brake pad into the caliper; then install the hair-pin clip NOTE: Lightly apply the brake lever to come to an easy stop; do not into the caliper assembly. over-apply brakes or “lock up” the 9. Repeat steps 5-8 for the inner pad; then track. secure the pad with the hairpin clip. 3. Repeat procedure 10-15 times 10. Remove the reservoir cover and allowing some cooling between remove the remaining fluid; then fill stops. the reservoir with fresh fluid and NOTE: Do not repeat too soon or install the cover. too aggressively as to get the brake 11. Pump the brake lever to ensure cor- disc “red hot.” rect positioning of the brake pads and proper brake lever travel (see ! WARNING Checking Brake Lever Travel subDo not attempt sudden stops or put section); then release. yourself into a situation where a sud- NOTE: If brake lever travel is not den stop will be required until the within specification, bleed the brake brake pads are properly burnished. system (see Bleeding Brake System NOTE: This procedure stabilizes sub-section). the pad material and extends the life 12. Remove the reservoir cover and fill of the pads. the reservoir (if necessary) to the proper level with fresh brake fluid; Drive Belt The drive belt transfers power from the then install the cover. drive clutch to the driven pulley. If the 13. Secure the brake shield, the driven belt is worn, cracked, or stretched, maxipulley (tightened to 20 ft-lb), and the mum power will not be transmitted and rear belt guard; then close and the belt could also fail and therefore must secure the left-side access panel. be replaced. Periodic checks (at least once a month under normal usage) of two drive belt specifications are essential. 43