Download SERVICE MANUAL MICRO Hi

HCD-CP100/CP100K
SECTION 4
TEST MODE
[Cold Reset]
• The cold reset clears all data including preset data stored in the
RAM to initial conditions. Execute this mode when returning
the set to the customer.
Procedure:
1. Turn ON the power.
2. Press three buttons x (TAPE), x (CD), and [BAND]
simultaneously.
3. The set is reset.
[CD Aging Mode]
This mode can be used for operation check of CD section.
Procedure:
1. Load a CD disc.
2. Set to standby state.
3. Press three buttons of x (TAPE), x (CD), and [TUNING --]
simultaneously.
4. The aging is executed in bellow sequence.
5. To exit from the aging mode, press the I/1 button to turn the
power OFF.
[Liquid Crystal Display All Lit Check Mode]
Aging mode sequence:
Procedure:
1. Set to standby state.
2. Press three buttons of x (TAPE), x (CD), and
[TUNING MODE] simultaneously.
3. Liquid crystal display are all turned on.
4. To exit from this mode, press the I/1 button to turn the power
OFF.
[Tape Deck Aging Mode]
This mode can be used for operation check of tape deck section.
Procedure:
1. Set a tape in the tape deck.
2. Set to standby state.
3. Press three buttons of x (TAPE), x (CD), and [TUNING +]
simultaneously.
4. The aging is executed in bellow sequence.
5. To exit from the aging mode, press the I/1 button to turn the
power OFF.
Aging mode sequence:
Start
FWD Play
Shut off
1 minute
REC pause for 3 seconds
FWD REC
Shut off
3 minutes
Fast forward
REV Play
Shut off
1 minute
REC pause for 3 seconds
REV REC
3 minutes
Rewind
12
Shut off
Start
Open the disc tray
Close the disc tray
Play the last track