Transcript
Detaching the Light V5 Instruction Manual Detach the light as shown in the picture. Features V5 is a flashing rear light that can be mounted on a bike seat post or attached to a backpack or waist band Integrated belt clip Recessed button to prevent accidental operation Acts as reflector when not turned on Splash proof The light can also be installed on your backpack or waist band easily. Operation Package Content V5 Light Seatpost Bracket Rubber Shim 2 x AAA Batteries Instruction Manual Press LED 1 LED 2 LED 3 Illustration LED 4 Press the button momentarily to switch between OFF-FLASH-OFF Modes. LED 5 Button Warranty Battery Door & Belt Clip Back Installation Installing the Battery The light is powered by 2 x AAA Batteries. 1. Open the battery door as shown in the picture 2. Install 2 x AAA batteries. 3. Close the battery door until you hear a “CLICK”. Installing the Light to the Bicycle Install the Seatpost Bracket with the rubber pad in it. VETTA WARRANTS ALL VETTA (The Company) PRODUCTS AGAINST MANUFACTURER DEFECTS FOR A PERIOD OF 3 YEARS. Subject to the following limitations, terms and conditions, components will be free of manufacturing defects in materials and workmanship. The 3 year limited warranty is conditioned upon the components being used and operated in normal riding conditions. This warranty does not cover normal wear and tear (i.e. battery replacement, broken wire), rider abuse, acts of God, improper installation or product alteration. This warranty is void if the components were not purchased (new) from or through an authorized VETTA retailer or dealer. Examples of unauthorized dealers are online auction sites or online retailers. VETTA at its sole discretion will repair or replace items at its own cost. Users are responsible for all freight and shipping charges when returning items for warranty service. In USA, you must either contact the retailer where the product was originally purchased from, or contact VETTA distributor in your country for customer service. Outside USA, you should contact the local dealer or VETTA distributor in your country for customer service. Rubber Pad Seatpost Bracket Slide the light onto the Seatpost Bracket until you hear a “CLICK”. Use your finger to pry out the belt clip to slide the light onto the Seatpost Bracket easily. The Company shall not be held responsible for replacing items with new items for greater than the amount of the original item purchase price. This limited warranty does provide the original owner with certain legal rights and recourse. The original owner may possess other rights or recourse, depending on the state or country. Please check the web to help answer any question and service manual. P/N: 81-121901-00 Front Installing the Light to Other Places