Download Read instructions before operating the machine.
Transcript
OPERATION PRE-RUN INSPECTION HIGH PRESSURE HOSE NOTE: Operation of this unit is simple. However, only trained personnel should proceed. Before starting the unit, connect the pressure hose to the outlet connection at the front of the unit. Connect the cleaning tool to the pressure hose. Operate this unit and equipment only in a wellventilated area. Exhaust fumes contain carbon monoxide which is an odorless and deadly poison that can cause severe injury or fatality. DO NOT operate this unit where the exhaust may enter any building doorway, window, vent, or opening of any type. DANGER WATER UNDER HIGH PRESSURE AT HIGH TEMPERATURE CAN CAUSE BURNS, SEVERE PERSONAL INJURY, OR COULD BE FATAL. SHUT DOWN MACHINE, ALLOW TO COOL DOWN, AND RELIEVE SYSTEM OF ALL PRESSURE BEFORE REMOVING VALVES, CAPS, PLUGS, FITTINGS, FILTERS AND BOLTS. CHECK FOR ADEQUATE FUEL Check the fuel tank to be certain there is adequate fuel to complete the job. This unit uses approximately .75-1.00 gallons of fuel per hour, depending on the speed setting. REMOVE TOOLS FROM VEHICLE Remove any tools or hoses from the van which you will require. ROTATING MACHINERY. WATER UNDER PRESSURE AT HIGH TEMPERATURE. IMPROPER MODIFICATION OF EQUIPTMENT CAN CAUSE SEVERE PERSONAL INJURY OR COULD BE FATAL. DANGER DO NOT MODIFY UNIT WITHOUT WRITTEN PERMISSION FROM MANUFACTURER VACUUM HOSE Connect the vacuum hose to the vacuum inlet connection at the front of the unit. Connect the other end of the vacuum hose to the cleaning tool. FILTERS WATER SUPPLY CONNECTION NOTE: Before connecting your water hose to the supply faucet, flush out the faucet until the water is free of any debris. Flush out any debris which may be in your water inlet hose. Ensure all filters on machine and in waste tank are free of debris. 1. Connect the water supply hose to the water inlet quick-connect at the left front of the console. Connect the hose to the water supply faucet. NOTE: Never use your waste pump outlet hose as a water inlet hose. Use only clean hoses for water inlet. 2. Turn the water supply faucet on. The water will fill the water box. PEAK 86037220 05/22/08 3-11