Download OptiMelt Automated Metling Point System

Transcript
Safety and Preparation For Use
iii
generally regarded as an important defense against electrocution. However, the use
of a GFCI in conjunction with the OptiMelt must NOT be regarded as a
substitute for proper grounding and careful connections. GFCI's must also
be tested regularly to verify their functionality. Always consult an electrician when in
doubt.
•
Do not use accessories not recommended in this manual as they may be hazardous.
•
Always turn off the power to the instrument before connecting any
cable or accessory to the unit.
•
Keep all electrical wiring on your laboratory benches neatly organized and in good
working conditions. Label and color-code all high voltage cables. Inspect all HV
wires periodically for problems as part of your safety checkups.
•
Use tie downs and cable channels to hold all electrical wiring in place (i.e. no
dangling cables).
•
Keep all electronic instrumentation neatly organized, and remove unconnected cables
power supplies and connectors from your laboratory benches and shelves.
•
Do not push objects of any kind into this product through openings as they may come
in contact with dangerous voltage points or short out parts that could result in a fire
or electric shock.
•
Operation of this product with line voltages other than those accepted by the power
supply can cause damage to the instrument and injury to personnel.
Burn Risks
A common risk associated specifically with the operation of thermal
analysis instrumentation equipment is burns.
•
Observe, and respect, the “HOT LID” warning on the top surface of the product.
•
Do not touch the heater block while hot.
•
Check the temperature of the block before opening its compartment.
Explosion Risks
Injury due to explosion is another important safety concern during the
operation of thermal analysis instrumentation.
•
This product is not compatible with application environments requiring: explosionproof equipment, or compatibility with samples which may explode or ignite by heat,
friction or spark.
•
Do not use this product to analyze samples of unknown composition or
contamination.
OptiMelt Automated Melting Point System