Download OptiMelt Automated Metling Point System
Transcript
Safety and Preparation For Use iii generally regarded as an important defense against electrocution. However, the use of a GFCI in conjunction with the OptiMelt must NOT be regarded as a substitute for proper grounding and careful connections. GFCI's must also be tested regularly to verify their functionality. Always consult an electrician when in doubt. • Do not use accessories not recommended in this manual as they may be hazardous. • Always turn off the power to the instrument before connecting any cable or accessory to the unit. • Keep all electrical wiring on your laboratory benches neatly organized and in good working conditions. Label and color-code all high voltage cables. Inspect all HV wires periodically for problems as part of your safety checkups. • Use tie downs and cable channels to hold all electrical wiring in place (i.e. no dangling cables). • Keep all electronic instrumentation neatly organized, and remove unconnected cables power supplies and connectors from your laboratory benches and shelves. • Do not push objects of any kind into this product through openings as they may come in contact with dangerous voltage points or short out parts that could result in a fire or electric shock. • Operation of this product with line voltages other than those accepted by the power supply can cause damage to the instrument and injury to personnel. Burn Risks A common risk associated specifically with the operation of thermal analysis instrumentation equipment is burns. • Observe, and respect, the “HOT LID” warning on the top surface of the product. • Do not touch the heater block while hot. • Check the temperature of the block before opening its compartment. Explosion Risks Injury due to explosion is another important safety concern during the operation of thermal analysis instrumentation. • This product is not compatible with application environments requiring: explosionproof equipment, or compatibility with samples which may explode or ignite by heat, friction or spark. • Do not use this product to analyze samples of unknown composition or contamination. OptiMelt Automated Melting Point System