Download Edge Evolution Programmer Installation Instructions & Manual

Evolution
07.5-09 LMM Duramax
Figure #5
4. To secure the pod: Remove bracket kit and pod from the Evolution box.
Note that the brackets are numbered and will be placed in the appropriate
numbered locations inside the pod. The double sided tape on the bracket
is attached to the inside pod surface over matching numbers.
NOTE: Be sure to check the position of the brackets while the Pod is resting
in its desired location on the dash prior to attaching them to the Pod with the
double sided tape over the matching numbers.
Clean the pod location on the dash with hot soapy water and
rinse, or use 70% Isopropyl alcohol. Make sure dash is completely
dry. Attach the supplied Velcro to the bottom of the mounting
brackets in the pod. Leave the protective backing on the bottom
piece of Velcro, and test fit the pod so you have an idea of where
you want it. Once you have determined the appropriate
positioning, remove the backing paper from the Velcro, place the
pod in it’s desired location, and firmly press down on the brackets
(through the front of the pod) to secure the Velcro in place.
5. Insert the rubber gasket into the Pod, and connect the Evolution to the
cable (Figure #6).
21