Download 2001-2010 Monarch II Installation Instructions

PREPARING THE MOTORCYCLE
Fig. 1
Brake System Modification- Front
1. Remove front fenders and wheel covers.
2. See Fig’s. 1 & 2. Remove OEM line from antidive valve and front master cylinder. Line continues to junction block located on steering
head. Disconnect lower hard line from block.
Remove block from frame and remove entire
line from motorcycle.
3. See Fig. 3. Install new brake line between antidive valve and master cylinder using OEM
banjo bolts and the following hardware. Torque
banjo bolts to 18 ft-lbs.
•
(1) Front brake line- S002066
•
(4) Copper Banjo Washers– GC6002
Anti-dive valve
Master cylinder
Fig. 2
Remove lower
line from block
Fig. 3
New line installed
16
Disconnect
block