Download Service Manual Mid-Size Walk Behind
Transcript
MOWER DECKS 3. Remove the knobs holding the belt covers to the cutting unit and remove the belt covers. 4. Remove the PTO drive belt. Refer to "Replacing the PTO Drive Belt (Floating Deck) 44 & 52 in. (111 & 132cm)" on page 7 - 7. 5. Disconnect the idler arm spring to relieve tension on the idler arm and idler pulley, then remove the worn deck belt (Figure 159). 10. Reinstall the belt covers onto the cutting unit, then reinstall and tighten the knobs/rubber washers. 6. 11. Reinstall the carrier frame cover onto the cutting unit, then reinstall and tighten the knobs/rubber washers. Install the new deck belt around the two outside spindle pulleys, the idler pulley, and in the lower groove of the center spindle pulley (Figure 159). 7. Connect the idler arm spring (Figure 159). 8. Reinstall the PTO drive belt. Refer to "Replacing the PTO Drive Belt (Floating Deck) 44 & 52 in. (111 & 132cm)" on page 7 - 7. 9. Adjust deck belt guide to 1/8 in. (3mm) from belt (Figure 159). 7. Install the new drive belt onto the PTO engagement pulley and the top groove of the center spindle pulley (Figure 158). 8. Install belt onto idler pulleys and then install idler spring (Figure 158). 9. Install the heat shield to the engine deck and carrier frame. 10. Reinstall the deck covers onto the cutting unit, then reinstall and tighten the knobs. 11. Install the carrier frame cover onto the cutting unit, then install and tighten the hand knobs. Figure 158 (1) PTO clutch pulley (2) Drive belt idler (3) Drive belt (4) Double spindle pulley Replacing the Deck Belt (Floating Deck) 44 & 52 in. (111 & 132cm) Squealing when the belt is rotating, blades slipping when cutting grass, frayed belt edges, burn marks and cracks are signs of a worn deck belt. Replace the deck belt if any of these conditions are evident. 1. Stop the engine, remove the key and disconnect the spark plug wire(s) from the spark plug(s). 2. Remove the knobs holding the carrier frame cover and remove the carrier frame cover. 7-6 Figure 159 (1) Deck belt (2) Idler arm spring (3) Outward pulley m-5194-2 (4) PTO drive belt (5) Center spindle pulley (6) Deck belt guide Mid-Size Walk Behind Service Manual