Download Section 3 - Installation & Maintenance

©Kaydon Corporation Issue 11 Slewing Ring Bearings Catalog 390
Installation & Maintenance
TABLE 3-22
ALLOWABLE TILT INCREASE
(in)
The increase in tilt is the difference in the last reading taken
and the initial reading taken prior to the equipment
beginning service. The maximum permissible increase in tilt
is shown in Table 3-22 according to rolling element type
and diameter. Replace the bearing when the difference
exceeds the values shown in Table 3-22. Contact Kaydon
should there be additional questions.
2.5.8 Dismantling and Disposal
Should it be necessary to remove the bearing from the
equipment, proceed in reverse order of that used for
installation or as close as safely possible.
Ball
Roller
(in)
(in)
(in)
0.625
0.030
0.010
0.750
0.035
0.012
0.875
0.040
0.013
1.000
0.045
0.016
1.125
0.050
0.018
1.250
0.055
0.020
1.375
0.060
0.022
1.500
0.065
0.024
1.750
0.075
0.028
2.000
0.080
0.032
2.250
0.090
0.036
2.500
0.100
0.040
2.750
0.110
—
3.000
0.115
—
Section 3
Tilt Measurement Position
Figure 3-21
Style
Diameter
Dw
Installation & Maintenance
Rolling Element
Where Dw = Diameter of rolling element
Contact a Kaydon representative concerning potential for
repair or replacement. Disposal shall be in accordance with
environmental and other local regulations applicable to the
materials used.
1-800-514-3066 www.kaydonbearings.com
43