Download EM: ENGINE MECHANICAL v.2011(Diesel)

INTAKE MANIFOLD
< SERVICE INFORMATION >
- Tighten intake manifold bolts and nuts in numerical order as
shown.
•
: Front
- If stud bolts were removed, tighten them to specification.
Stud bolts
[YD25DDTi]
A
EM
: 10.8 N·m (1.1 kg-m, 8 ft-lb)
C
ALBIA0602ZZ
D
•
•
•
Install EGR cooler and EGR volume control valve, if equipped.
Install water hoses and heater feed hose.
Install water hose by referring to paint marks and avoid twisting.
When an insert stopper is provided on the pipe side, insert the hose until it reaches the stopper.
Before starting engine, bleed air from fuel piping. Refer to EC-481, "Fuel Filter" or EC-726, "Fuel Filter".
INSPECTION AFTER INSTALLATION
E
F
Start engine and increase engine speed to check for fuel leak.
CAUTION:
Do not touch the engine immediately after stopped as engine becomes extremely hot.
NOTE:
Use mirrors for checking at points out of clear sight.
G
H
I
J
K
L
M
N
O
P
Revision: March 2011
EM-97
2011 D22 LCV