Download 751 solucion de fallas

Transcript
bizhub 751
Controller - no or slow print, scan failure, garbled data, lockup
SOLUTION:Delete the files from the CF card and write thebase level 10 files directly tothe card.Only delete the files from the CF card and copy the new files
from the Base firmware download to it. This will recover the machine.
IMPORTANT : Change the administrator password before upgrading firmware beyond the base level.To do this, perform the following:
1. Enter Service Mode.
2. Press Stop,0, Clear on the 10-key pad of the control panel.
3. Touch Administrator Password.
4. Enter the administrator password.
5. Touch End.
From this point, flash the machine as normal to the latest firmware version. The latest version firmware or system software is available via the Konica Minolta
Download Selector. Access the Selector from SSD Web Support (CS Expert Support) by clicking on 'Download MSDS, Drivers, Firmware and more'.
If the problem is not resolved, please replace the CF card (p/n A0PN R722 00).
IMPORTANT : DO NOT FORMAT THE CF CARD as this willrender the card unreadable.
Note : There is a different part number for the bizhub 601/751 CF card if version 20 firmware or later is installed. (p/n A0PN R722 11)
SPECIAL NOTE : Solution contribution by Bill Hall, Workgroup/SSD
Solution ID
TAUS1000835EN*
Solution Usage
3
Solution Usage
2
Solution Usage
2
Description
"Device not supported" message when trying to initiate scanning.
Solution
CAUSE: A different driver needs to be used.
SOLUTION: Install the Real-Time NonGUI TWAIN special driver is to support these models.
This driver adds the support for:
C552DS/C652DS
C452/C552/C652: Ver.90
C220/C280/C360: Ver.88
601/751: Ver.20
223/283/363/423
NOTE: The driver can be downloaded at ftp://special:[email protected]/twain/KMRMTW_Ver3.1.2.26_NoGUI.zip
SPECIAL NOTE: Solution contribution by Paul Santangelo, ESS
Solution ID
TAUS0653260EN*
Description
After installing the IC-203, printing over the network is not possible and the controller Configuration pagewill not print.
Solution
CAUSE: The IC-203 hard drive requires format upon initial installation.
SOLUTION: To format the IC-203 hard drive, perform the following:
1. Enter Tech Rep Mode.
2. Enter CE Password, as required.
3. Press [IP Hard Disk Format].
4. Select [ALL].
5. Select YES to [Execute Format].
6. Exit Tech Rep Mode.
Note :Controller settings are reverted back to factory default.
Solution ID
TAUS0900666EN*
Description
No print button. Print button missing in Admin mode.
Solution
CAUSE: IC208 was not installed. This is an Option.
SOLUTION: Install the IC208 chip (Item #A0P90Y1)
SPECIAL NOTE: Solution contribution by Don St. Onge, Workgroup/SSD
Copyright 2011, Konica Minolta Business Solutions U.S.A., Inc.
March 2011
5