Download occupant detection system (diagnostics)

Transcript
asieps_tobira.book 15 ページ
2005年9月24日 土曜日 午後4時27分
Control Module I/O Signal
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS)
6. Control Module I/O Signal
A: ELECTRICAL SPECIFICATION
CAUTION:
Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.
Terminal name
IG – power supply
Airbag control module communication
Airbag control module communication
Belt tension sensor
Occupant detection sensor
Buckle switch
Buckle switch
(COM)
(GND)
(Vcc)
(Vout)
(GND)
(Vcc)
(Vout)
(GND)
(GND)
Terminal
No.
9
10
5
4
16
14
6
7
15
1
2
Input/Output value
9 — 16 V
Open collector terminal
0V
0—5V
0.5 — 4.5 V
0V
0—5V
0.5 — 4.5 V
0V
0 — IG voltage
0V
Remarks
When ignition switch ON
Communication line
Ground
Belt tension sensor power supply
Sensor output voltage
Sensor ground
Pressure sensor power supply
Sensor output voltage
Sensor ground
Ignition voltage when switch ON
Switch ground
B: WIRING DIAGRAM
Refer to the electrical wiring diagram. <Ref. to WI-113, WIRING DIAGRAM, Seat Belt Warning System.>
OD(diag)-15