Download Rack Mount Remote Controller (1RU) I&O Manual
Transcript
RACK MOUNT REMOTE CONTROL UNIT the equipment is small is no assurance of safety. Dense packaging results in more difficult access and increases the chance that you will accidentally hit the wrong point. g. Always discharge high voltage capacitors. High voltage capacitors store a lot of energy for long periods of time. High voltage capacitors also exhibit a "memory" in that they can recover after discharge and reach lethal levels. In addition to the "memory" problem, there have been instances where the built-in safety features have failed or have been miswired. Each and every time you go to work on a piece of high voltage equipment, use a discharge device with a long handle to discharge every high voltage capacitor. h. Do not depend on the automatic features of the equipment to save you. You never know when someone has left a circuit disabled, if there has been a wiring error, or if a component has failed. i. Take personal responsibility to assure that no one can turn on the high voltage circuits when you are working on the equipment. Precautions would include taping down (or installing a keeper) on controls/circuit breakers and/or disconnecting the power source to the high voltage circuits, activating interlocks that prevent high voltage turn on, etc. Know where the power disconnects are and use them. Do NOT rely on anyone not to turn on the high voltage. j. Set up your test equipment with the power off. Conduct the power-on operations when you have your hands out of the equipment. k. Do not use short probes for high voltage measurements. A short probe does not allow any margin for error. If your hand slips you could accidentally come into contact with a danger point. A long probe avoids the whole problem. l. Read the instruction manual. The best insurance is foreknowledge of hazards. m. Create a favorable environment for safe operations. This means that if people are crowding you, stop the operation if it involves high voltage. Pressure can lead to carelessness. In the same way, fatigue is also an enemy. STAY ALERT AT ALL TIMES WHEN WORKING WITH HIGH VOLTAGE. n. Do not become over-confident. Maintain a healthy respect for high voltage. o. A good operating practice is to check the potential between the equipment chassis and earth ground before you complete DOC.01032319 REV.2 S-3