Download Fizzle High Efficiency Intercooler Kit Installation

Transcript
stock intercooler; connect one end to water outlet fitting on intercooler. Route loose end
towards exhaust side of engine, then forward and connect to hose barb fitting at
front/bottom of the exhaust manifold. Secure using the original hose clamp. NOTE: For
steps 17 & 20; take care not to kink hoses. It may be necessary to trim excess hose for
proper fit.
16. The following instructions 17A and 17B are the two basic methods for installing the
intercooler and bracket into their proper location. Choose the one that seems most
appropriate for your space constraints and mechanical ability. It is recommended to seal
the back face of the bracket support arm to the pump transom surface with silicone sealant
(gasket maker) in order to avoid potential water leaks from the pump support bolts. Keep
in mind that the intercooler bracket plate and the intercooler itself will need to be
attached in a way that they are both rotated slightly towards the supercharger. This is
essential in getting all of the piping to line up properly.
17A. Bolt the bracket plate and bracket arm together using the 3 supplied bolts and deep
cylinder washers. Then, place the intercooler onto the bracket mounting plate. Strap the
intercooler to the bracket plate by pulling the straps over the front of the intercooler and
hooking each ‘S’ hook to its respective attachment hole on the bottom side of the bracket
mounting plate. The rubber straps work best when they are diagonally crossed over each
other on top of the intercooler (see picture below). Once the intercooler is secured to the
mounting plate with the straps, hook the bottom of the bracket arm leg around the engine
coolant hose located near the pump transom. This will allow each of the holes on the
bracket arm to line up with its respective matching hole on the pump transom. To hook the
bracket arm around the large engine coolant hose you will have to turn the intercooler into
a specific orientation. The intercooler will have to be placed so that it is standing vertically
and sideways. In this position the back plate of the intercooler and mounting bracket will
be sitting on the bottom of the hull. The 2.75” air inlet and outlet openings will be facing
upwards. Once the curve in the bracket arm is hooked under the hose, rotate the
intercooler and bring it back to horizontal. This may not be necessary on the more spacious
GTX/RXT. Re-install the factory pump support bolts through the bracket arm once the
bracket arm is mating with the hull at the pump transom surface. The bolts with washers
will first go through the intercooler bracket arm, then into the pump support threads. Make
sure to fully tighten these bolts.
17B. Place the intercooler onto the bracket mounting plate. Strap the intercooler to the
bracket plate by pulling the straps over the front of the intercooler and hooking each ‘S’
hook to its respective attachment hole on the bottom side of the bracket mounting plate.
The rubber straps work best when they are diagonally crossed over each other on top of
the intercooler (see picture below). Take the bracket arm and put it in place against the
pump transom (with recommended silicone sealant). Re-install the factory pump support
bolts once the bracket arm is mating with the hull at the pump transom. The bolts with
washers will first go through the intercooler bracket arm, then into the pump support