Download Supplemental Restraint System

Transcript
Suppl. Restraint System
Components
Side Airbag Sensors
•
Side airbag sensors are only used in vehicles with side airbags and/or curtain airbags.
They are mounted close to each B-pillar in order to determine severity of a side impact.
The Tribute (EP) FL (Face Lift) is equipped with an additional side airbag sensor at each
C-pillar to ensure optimum protection for the occupants even if a side impact occurs at
the rear of the vehicle. The additional sensor is necessary, because of rotation of the
vehicle about the vertical axis an impact in the rearward area of the vehicle would not be
recognized by the front side sensors.
•
It incorporates an accelerometer and is connected to the SAS module.
•
Mazda uses two different types of side airbag sensors. One type features an integrated
saving sensor and triggers the corresponding side airbag directly via the SAS module.
The other sensor type detects the impact severity and sends a corresponding signal to
the SAS module where then the decision is made whether or not the corresponding
side/curtain airbag have to be triggered.
NOTE: The bolt of the side airbag sensor must always be tightened to the specified torque
(refer to W/M). Ensure that the sensor is correctly aligned, otherwise the
measurement results for the acceleration might be affected, causing a malfunction of
the SRS.
1003_109
1
2
Connector
Side airbag sensor
Curriculum Training
3
Bolt
02-7