Download OPERATOR`S MANUAL

Transcript
Troubleshooting
ENGINE
PROBLEM
POSSIBLE CAUSE
RECOMMENDATION(S)
Engine Hard to Start
or Will Not Start
Improper starting procedure
• See starting section of this manual. Take
special note of Bypass Switch operation.
No fuel
• Check level of fuel in fuel tank.
Low battery output
• Check electrolyte level and condition.
Excessive resistance
in starting circuit
• Clean and tighten all battery connections.
Crankcase oil too heavy
• Use oil of proper viscosity.
Improper type of fuel
• Consult fuel supplier and use proper type
of fuel for operating condition.
Water, dirt or air in fuel system
• Drain, flush, fill and bleed system.
Clogged primary
fuel filter element
• Clean or replace filter element.
Lift pump malfunction
• Repair lift pump.
Clogged secondary
fuel filter element
• Replace filter element.
Dirty or faulty injection nozzles
• Have your dealer check injection nozzles.
Below normal engine temperature
• Remove and check thermostat.
Clogged primary
fuel filter element
• Clean or replace filter element.
Clogged secondary
fuel filter element
• Replace secondary filter element.
Water or dirt in the fuel system
• Drain, flush, fill and bleed system.
Dirty or faulty injection nozzles
• Have your dealer check injection nozzles.
Air in fuel system
• Inspect clamps and hoses on suction side
of fuel pump for air leak.
Control lever adjusted incorrectly
• Adjust control lever
Improper type of fuel
• Consult fuel supplier and use proper type
of fuel for operating condition.
Uneven compression pressure
between cylinders.
• Check cylinder compression pressure.
Intake air restriction
• Service air cleaner, check proper ventilation.
Clogged primary
fuel filter element
• Clean or replace filter element.
Clogged secondary
fuel filter element
Injection pump not getting fuel
• Replace filter element.
Engine Runs Irregularly
or Stalls Frequently
Lack of Engine Power
Improper type of fuel
OM843NW3 11/13
25
• Have injection pump checked.
• Consult fuel supplier and use proper type of
fuel for operating conditions.