Download Service
Transcript
Trouble TOPIC POSSIBLE Ice maker is not producing ice (some models-continued) Improper CAUSE Shooting SOLUTION water valve was installed. Check water connection Instructions. Self-piercing procedure in your Installation and 3116"saddle valves cause low water pressure and may clog the line over time. Amana responsible for property damage due to improper installation or water connection. Unit is leaking water Ice forms in inlet tube to ice maker Water flow is slower than normal Dispenser water is not cold Plastic tubing was used to complete water connection. Amana recommends using copper tubing for installation. Plastic is less durable and can cause leakage. Amana is not responsible for property damage due to improper installation or water connection. Improper water valve was installed. Check water connection proce_Jure in your Installation Instructions. Self-piercing and V1G"saddle valves cause low water pressure and may clog the line over time. Amana is not responsible for property damage due to improper installation or water connection, Water pressure is low. Water pressure must be between 20 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for units with water filters. Freezer temperature See the controls section in your owner's manual for assistance on how to adjust your controls. Freezer is recommended to be between Oto 2°F (-18 to -17°C). is too high. Water pressure is low. Water pressure must be between 20 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for units with water filters. Improper water valve was installed. Check water connection proce£ture in your Installation Instructions. Self-piercing and V16" saddle valves cause low water pressure and and may clog the line over time. Amana is not responsible for property damage due to improper installation or water connection. Copper or plastic tubing has kinks. Turn off water supply and remove kinks. removed, replace tubing. Water filter is clogged or needs to be changed. Change water filter. Refrigerator Allow approximately chill. has been recently installed Water has settle into water lines outside holding tank and has warmed to room temperature. A- 22 If kinks cannot be !2 hours for water in holding tank to Water supply in holding tank has been depleted. RS1300005 Rev. 0 is not Discard first glass of water and refill.