Download Service

Transcript
Trouble
TOPIC
POSSIBLE
Ice maker is not producing
ice (some models-continued)
Improper
CAUSE
Shooting
SOLUTION
water valve was installed.
Check water connection
Instructions.
Self-piercing
procedure in your Installation
and 3116"saddle valves cause low
water pressure and may clog the line over time. Amana
responsible
for property damage due to improper
installation
or water connection.
Unit is leaking water
Ice forms in inlet tube to ice
maker
Water flow is slower than
normal
Dispenser
water is not cold
Plastic tubing was used to complete water
connection.
Amana recommends using copper tubing for installation.
Plastic is less durable and can cause leakage. Amana is
not responsible
for property damage due to improper
installation
or water connection.
Improper water valve was installed.
Check water connection proce_Jure in your Installation
Instructions. Self-piercing and V1G"saddle valves cause low
water pressure and may clog the line over time. Amana is
not responsible for property damage due to improper
installation or water connection,
Water pressure is low.
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for units with
water filters.
Freezer temperature
See the controls section in your owner's manual for
assistance on how to adjust your controls. Freezer is
recommended to be between Oto 2°F (-18 to -17°C).
is too high.
Water pressure is low.
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for units with
water filters.
Improper water valve was installed.
Check water connection proce£ture in your Installation
Instructions. Self-piercing and V16" saddle valves cause low
water pressure and and may clog the line over time.
Amana is not responsible
for property damage due to
improper installation
or water connection.
Copper or plastic tubing has kinks.
Turn off water supply and remove kinks.
removed, replace tubing.
Water filter is clogged or needs to be
changed.
Change water filter.
Refrigerator
Allow approximately
chill.
has been recently installed
Water has settle into water lines outside
holding tank and has warmed to room
temperature.
A-
22
If kinks cannot be
!2 hours for water in holding tank to
Water supply in holding tank has been
depleted.
RS1300005 Rev. 0
is not
Discard first glass of water and refill.