Download Scope Cleaner S20 - G-Flex

Transcript
Note
Cleaning and disinfection must be accurately documented in a traceable manner.
Supplied with the unit is an optional Zebra TLP2844 Printer system to enable you to
document this phase, which should be attached to the SCOPE-CLEANER S20.
The printout must then be stored in a suitable place; preferably inside the
service manual or in the file for the patient on whom the endoscope was used.
Listed in the label printing:
• The quantity and the time of each cycle;
• The hour and date for the procedure;
• The code of the device;
• The name/code of the responsible user ;
• The name/code of the patience;
• The disinfection life time;
• The total cycle realized by the unit;
• The unit ID;
Note
The unit has the option of storing information of the disinfection process using a USB
storage device (USB Flash Drive).
Recommended standard procedure
The recommended standard procedure consists of leakage test, prewashing,
disinfection and neutralizing:
1
2
3
4
Leakage test: 2 min.
Prewash: 4.5 min including 1min blow out.
Disinfection cycle: freely selectable+ 4 min (filling and emptying) including 1min blow out.
Neutralization: 7 min including 2 min blow out.
Total time = 18 min + disinfection time
Note
Perform the self-disinfection cycle without an endoscope once per working day after
endoscope processing has completed and if the machine has not been used for 12 hours
(refer to the Chapter entitled “Self-disinfection cycle for the SCOPE-CLEANER S20”)
Creation Date:
Current Name:
G-Flex Europe S.P.R.L. | 20, Rue de l’industrie 1400 Nivelles - Belgium
Phone: +32(0)67.88.36.65 | Fax: +32(0)67.88.36.88 | Email: [email protected] | Website: www.g-flex.com
US Commercial Office Only: G-Flex USA, Inc., 74 Southwood Pkwy Suite 600 Atlanta, GA 30354 – USA
18/10/13
IFU-ScopeCleanerS20.doc
This document is only controlled in electronic format by the QM.
Page:
Version:
8 of 87
7