Download Workshop Manual Service

Transcript
Audi A8 2003 ➤
Auxiliary Heater - Edition 03.2008
Note
♦ In Model Year 2008 production is
gradually being switched from
the Telestart “T90” version of the
remote control to the Telestart
“T91” type ⇒ page 10 and ⇒
Electronic parts catalogue .
♦ At present, a maximum of 3 re‐
mote controls can be adapted in
the remote control receiver for
auxiliary heater -R64- . Adaption
of a fourth remote control causes
the first matched remote control
to be erased.
♦ The signals from the remote con‐
trol hand transmitter are only re‐
layed by the remote control re‐
ceiver for auxiliary heater -R64- .
The signals are then processed
by the supplementary heater
control unit -J364- ⇒ "Guided
fault-finding" function of vehicle
diagnostic, testing and informa‐
tion system VAS 5051 (reading
measured value block).
♦ The remote control receiver for
auxiliary heater -R64- can be de‐
activated by the supplementary
heater control unit -J364- (thus
reducing the no-load current in‐
put) ⇒ "Guided fault-finding"
function of vehicle diagnostic,
testing and information system
VAS 5051 (reading measured
value block).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted
unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
♦ Checking signals from
the re‐
with respect
mote control receiver for
auxili‐to the correctness of information in this document. Copyright by AUDI AG.
ary heater -R64- ⇒ "Guided
fault-finding" function of vehicle
diagnostic, testing and informa‐
tion system VAS 5051 (reading
measured value block).
98
Rep. Gr.82 - Auxiliary heating